Spray Shop Supplies


or make 4 interest-free payments of $19.99 AUD fortnightly with Afterpay More info



Ready for Use 

Is a sprayable quick drying nitrocellulose lacquer paint. It is used for painting subframes, radiators, boots, differential and tailpipes. Used widely in the automotive detailing industry for under wheel arches, inside boots and used as a Guide Coat Black.

May also be applied by brush or components may be dipped.

PRIOR TO APPLICATION: Wax & Grease Remover “Should Not Only” be used prior to priming or colour coating. It is also recommended to be used before sanding or grinding commences.

This is often neglected at the risk of expensive “Rework or Come Backs”. Use 2 cloth method, wipe on wet and wipe off immediately, changing to new rags frequently, work in small areas, do not allow wax and grease to dry out on the job. After cleaning, leave 15 minutes before painting.

THINNING RATIO AND APPLICATION: Thoroughly stir contents of can.

Master GMH Flat Black is normally ready for use (RFU) but may be thinned with General Purpose Thinner if required. Apply using a suction fed spray gun with a 2mm air cap set up with an air pressure of 345kpa to 410kpa (50-60psi). Only one coat of Master GMH Flat Black is normally applied, however should additional coats be required, allow 5 minutes flash off time between coats. DRYING: Touch dry in 5-10 minutes. Dry to handle in 30 minutes at 20°C. NOTE: Avoid spraying under conditions of humidity higher than 80% or temperatures lower than 10̇C. Spray only in a well ventilated and clean area. o not apply to hot surfaces or in direct sunlight. Mask off surrounding areas to avoid overspray.

CLEAN UP: Using General Purpose Thinner or Gun Wash. STORAGE: Keep the container tightly closed. Store in a cool, dry, well ventilated place. Store locked up.

Our brands