Quicksilver Silver Gal Paint 2 Litre

FEATURES

RECOMMENDED USES

Quicksilver is a premium quality, extremely rapid drying silver alkyd enamel. The bright silver appearance is due to the presence of metallic aluminium, which also acts as an anticorrosive pigment

Due to its unique polymer system, Quicksilver provides the maximum in gloss, durability, flexibility, strength and hardness.

Quicksilver is a general industrial rapid dry silver enamel finish, and can be applied to protect suitably primed:

• Metal implements
• Machinery and equipment
• Mining and engineering equipment
• Office and electrical equipment

DIRECTIONS FOR USE

Ensure all surfaces are clean, dry, and free from contamination.

Quicksilver is best applied by conventional or airless spray. Add the appropriate amount of Cameleon E243 Thinner depending on the type of application equipment and environmental conditions. Typical conventional spray set up should have air pressures of Pot: 60 - 100 kPa (10 - 15 psi); Gun: 380 - 420 kPa (55 - 60 psi). Airless spray set up should have a 28:1 pump ratio and an air supply of 520 - 650 kPa (80 - 100 psi). Apply one mist coat, allow to flash off then apply one full coat. Recoat within 1 - 2 hours, or after 24 hours.

Stir well before use. Provide adequate natural ventilation during use. Wash equipment immediately after use with Thinner E243 or Enamel Thinner.

DO NOT apply if temperature is below 10°C or if relative humidity is >85%

Surface

Preparation

System

Dry Film Build

Steel

Ensure surface is clean, dry and free from grease, oil, or other surface contaminants. Abrasive blast to AS1627.4 class 2, or power tool clean to AS1627.2

1. Metalprime; or
   Satin Prime IP415
2. Quicksilver

50µ

70 - 80µ ⁽²⁾

Aluminium, Zinc Alum or galvanised metals

Thoroughly scrub the surface to remove any white corrosion products and surface contamination (oil, grease etc). Prepare substrate to SSPC-SP-1.

1. Cametch VP628
2. Quicksilver

15 - 20µ

70 - 80µ ⁽²⁾